Conveyor Accessories

TRANSFER PLATE WITH LIP, WITH STAINLESS STEEL FASTENER

MUSHROOM END CAP, IN BLACK RUBBER, no. 020-M-CAP-B, 1/2’’ I.D., FOR 1/2’’ STAINLESS STEEL RODS X 2-1/4’’ O.D.

END CAP IN BLACK VINYL, no. 020CAP-B, 1/2’’ I.D. X 1’’ LONG, FOR 1/2’’ STAINLESS STEEL RODS

MINI POSITIVE ACTION CROSS BLOCK, no. 732-MINI-13182, FOR ROUND RODS 1/2" X 1/2"

"NOSE BAR" AND PLATE KIT, no. 905-655711, 6" WIDE WITH NYLATRON EDGE

Closing cap 343-69703, in black polypropylene, for 10mm diameter tube x 1mm wall

Finger transfer plates (combs) are installed at the belt ends of a raised rib belt. The fingers extend between the ribs of the belt for smooth product transfer.

A complete line of hand knobs Elesa is available on request, with male or female thread, imperial or metric thread, zinc plated steel or stainless steel. Contact us for more information.

Small Cross Block for Photocell Accessories, Series 340, Made in black polyamide (Nylon, PA)

A complete line of handles Elesa is available on request, with male or female thread, imperial or metric thread, zinc plated steel or stainless steel. Contact us for more information.

A complete line of hinges Elesa is available on request. Contact us for more information.

A complete line of indicators Elesa is available on request, gravity or positive drive, numerical or analog display and now offered in electronic version. Contact us for more information.

A complete line of adjustable handles Elesa is available on request, with male or female thread, imperial or metric thread, zinc plated steel or stainless steel. Contact us for more information.

HINGE, no. P37202, IN BLACK POLYAMIDE

SMALL HINGE, no. P37301, IN BLACK POLYAMIDE

T-CLAMP, FOR SIDE MOUNT OF RODS, IN BLACK POLYAMIDE

CROSS BLOCK no. P381, IN BLACK POLYAMIDE

MINI CROSS BLOCK, IN BLACK POLYAMIDE, FOR ROUND OR SQUARE RODS.

CROSS BLOCK, IN BLACK POLYAMIDE, WITH 2 KNOBS

Small T-Clamp for Photocell Accessories, Series 339, Made in black polyamide (Nylon, PA)

Small Clamp for Photocell Accessories, Series 341, Made in black polyamide (Nylon, PA), for 3/4" sensor, with options on mounting rod size.

Photocell reflector clamp 341C-67215, in black polyamide, for installation on 10mm round rod or 8mm square rod

Support no. 372-61806, in black Polyamide, 5/8" bore, for photocell accessories

Stainless steel 303 rods, 1/2" dia., Plain finish (Without thread or groove)